![]() |
|
|
|
[ Thu, 28 Apr 2005 23:40:19 GMT
] [ 152646 ] [ alt.building.construction ] [ view full article ] Bob Morrison - Re: Removing old roof , and replacing with trusses - In a previous post says... > The existing roof is deflecting under snowload, there is no attic space, and > I wish to have proper eave ventilation. > Jason: I recommend that you block up on top of the exterior walls between the ceiling joists to get a flush surface. Then add a 2x flat above the top of the joists, to give you a new sill plate. Set your new trusses on to... |
[ Thu, 28 Apr 2005 17:30:39 -0500
] [ 152645 ] [ alt.building.construction ] [ view full article ] "DanG" - Re: Oversize Brick-Residential-Any Bricklayers?? - Sounds like slurry faced brick as opposed to hard fired brick. If the houses already going up it sounds a bit late to be asking the questions. Work with the brick supplier, show him your dilemma, discuss warranty, etc. You might also get some good information at this site: http://www.bia.org/ (top posted for your convenience) ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^ Keep... |
[ 28 Apr 2005 11:49:28 -0700
] [ 152643 ] [ alt.building.construction ] [ view full article ] tbasc@bellsouth.net - Re: a few questions about deck construction - Choose your deck elevations and attach the joists either way. longshot says place one set of joists on top of the beam. That's o.k. if you have enough clearance to the ground and if the step height is o.k. I could send you dwgs after I get back into town. in about a week. TB . ... |
[ 28 Apr 2005 11:15:33 -0700
] [ 152641 ] [ alt.building.construction ] [ view full article ] "yaofeng" - Re: Paslode Nail Gun - Being Made in China ! - OT - I commend those ceo's for doing their job. They are at least saving some jobs in the domestic sector rather than giving the business away to the competitor. . ... |
[ ] [ 152635 ] [ alt.building.construction ] [ view full article ] "longshot" - Re: a few questions about deck construction - -- > > I wonder- do you have a www site with a diagram of how the beam and > hangers are arranged at the change in elevation? Does the upper > elevation sit ON the beam and the lower HANG on the side of the beam? > > THanks > BX1 > I would overlap the top & beam to sit flush & place a few splice plates across the gap . ... |
[ 28 Apr 2005 09:22:49 -0700
] [ 152631 ] [ alt.building.construction ] [ view full article ] "Buell Boy" - Re: a few questions about deck construction - Thank-You for this detail and to everyone. I wonder- do you have a www site with a diagram of how the beam and hangers are arranged at the change in elevation? Does the upper elevation sit ON the beam and the lower HANG on the side of the beam? THanks BX1 . ... |
[ 28 Apr 2005 05:18:19 -0700
] [ 152625 ] [ alt.building.construction ] [ view full article ] tbasc@bellsouth.net - Re: a few questions about deck construction - Since you don't show a layout of the deck, one can only answer in generalities. Many levels & only 20 joists seem difficult to match. (1) Place a beam along the changes in deck elevation. Frame the joists ... |
[ Wed, 27 Apr 2005 17:12:56 -0500
] [ 152614 ] [ alt.building.construction ] [ view full article ] "DanG" - Re: Curved framing under tile - Make the top and bottom plate of pressure treated ply. Pressure treated studs, go to 12" centers. Use either 1/2 or 5/8 Durock, comes in 4x8 sheets. It will make your curve just fine. If you have a radical curve, go here: http://www.unifixinc.com/products/permabase-flex.htm (top posted for your convenience) ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^ Keep the whole world singing . . ... |
[ Wed, 27 Apr 2005 17:09:32 -0400
] [ 152612 ] [ alt.building.construction ] [ view full article ] "John D. Coleman" - Re: Cost of Illegals in TX - On Wed, 27 Apr 2005 12:13:03 -0500, Don Carpenter wrote: > On Tue, 26 Apr 2005 23:41:03 -0400, John D. Coleman wrote: >> Sounds like a good idea. How about stocking the Rio Grande with >> "nuisance" alligators. >> >> Any government official endorsing these plans would be skinned alive by >> the public. Too bad. > > They are people too -- just trying to escape massive poverty a... |
[ ] [ 152609 ] [ alt.building.construction ] [ view full article ] "Phil Scott" - Re: Curved framing under tile - "Rich-out-West" |
[ 27 Apr 2005 10:21:11 -0700
] [ 152607 ] [ alt.building.construction ] [ view full article ] "Rich-out-West" - Curved framing under tile - Hello, I need to frame a tub surround to support a Kohler K-1314 Symbio corner tub. This unit sits in the corner and has a curved front edge. My plan is to build a 2x4 stub wall that supports the deck and then tile the wall and deck. Since this wall rests on a slab and it obviously could see moisture from the tub, I need the framing to be rot resistant. If it was a straight w... |
[ Wed, 27 Apr 2005 08:05:59 -0700
] [ 152604 ] [ alt.building.construction ] [ view full article ] G Henslee - Re: Leveling recessed shower shelves - Mike wrote: > G Henslee wrote: > >>Unless the tile will cut itself, I suppose you'll have to cut them to > > >>fit the recess. > > > :) > > I meant: Should I fabricate smaller tiles (3/4 x 3/4?), giving me more > grout lines on the shelf. No. . ... |
[ Wed, 27 Apr 2005 07:13:51 -0700
] [ 152600 ] [ alt.building.construction ] [ view full article ] G Henslee - Re: Leveling recessed shower shelves - waterrockets@gmail.com wrote: > How are recessed tile shower shelves supposed to be leveled? I'm > interest in the floor of the recess, where the soap or shampoo will > rest. It seems the you need a slope to get the water out, yet you don't > want the soap sliding out on its own. > > The shower I'm tiling has 6x6 ceramic tile walls. Someone told me that > you can alternate the slope... |
[ 27 Apr 2005 05:57:29 -0700
] [ 152598 ] [ alt.building.construction ] [ view full article ] waterrockets@gmail.com - Leveling recessed shower shelves - How are recessed tile shower shelves supposed to be leveled? I'm interest in the floor of the recess, where the soap or shampoo will rest. It seems the you need a slope to get the water out, yet you don't want the soap sliding out on its own. The shower I'm tiling has 6x6 ceramic tile walls. Someone told me that you can alternate the slope of smaller tiles on the shelf, but I'm not ... |
[ ] [ 152585 ] [ alt.building.construction ] [ view full article ] M&S - Re: Labor, future craftsmen, undocumented workers - heck wrote: > M&S wrote: > >>heck wrote: >> >> >>>Would it be better for the local economy to buy a Toyota from the > > local > >>>Toyota dealer, or would it be better for the local economy to take > > my > >>>money to Mexico and buy a toyota from a Mexican Toyota dealer? >>> >> >>Heck, >> I cant resist. Are you under 25? >> >>Mark > > > N... |
[ Tue, 26 Apr 2005 22:51:09 GMT
] [ 152583 ] [ alt.building.construction ] [ view full article ] Robert Allison - Re: Cost of Illegals in TX - Tom Cular wrote: > When you look at costs like those below, how can anyone justify the so > called "need" for these folks. > > Tom > > Over 1.2 million illegal aliens are living in Texas, estimates the Migration > Policy Institute.44 This is an increase of 500,000 or 71 percent, since 1996 > and an increase of 843,000 or 236 percent, since 1992. > ... |
|
<Rentals>
<House Exchanging>
<Frequently Asked Questions>
<Add Article>
<Help>
<Terms & Conditions>
<Guestbook>
<Prices>
<Tips on writing your listing>
<Real Estate Forums>
<News>
<Press Room>
<Success Stories>
<Estaplace.com History>
<Webmaster's Tools>
<Copyright>
<About Our Team>
<Search Real Estate Agents>
<E-Mail Us>
[ USA -> CHICAGO - 12/July/2025 07:55:38 ]
We have 24807 properties listed. Yesterday traffic on Estaplace Real Estate was: 4352
unique visitors with 162297 page views. To view more statistics about
Estaplace Real Estate, click here.
|
Estaplace.com is a worldwide and international real estate directory, with thousands
of real estate listings, divided into countries and regions. All material, the structure, and the layout on this site
are © Copyright of Estaplace.com by Ceglia Giovanni located in Trento N. 74 Pal. I Street in Pagani(Salerno) - Italy.
Italian Business Code: Partita IVA N. IT03972320653, registered in the "Camera di Commercio" of Salerno.
Estaplace.com is one the Ceglia Giovanni projects, started on 20 July 2005, and online since 20 August as a real estate platform for listings, mainly operating on the Italian and American/English market in the Internet, Estaplace would like to become the point of referiment for home sellers and home buyers, a site where private owners or real estate agencies can have the possibility to show their offers to the world. Estaplace.com is only one of the Giovanni Ceglia's sites. Everyday Giovanni Ceglia works to improve new Internet tools and services for online marketing and business. Estaplace.com will become the biggest portal for real estate business and investments online.
Estaplace.com is one the Ceglia Giovanni projects, started on 20 July 2005, and online since 20 August as a real estate platform for listings, mainly operating on the Italian and American/English market in the Internet, Estaplace would like to become the point of referiment for home sellers and home buyers, a site where private owners or real estate agencies can have the possibility to show their offers to the world. Estaplace.com is only one of the Giovanni Ceglia's sites. Everyday Giovanni Ceglia works to improve new Internet tools and services for online marketing and business. Estaplace.com will become the biggest portal for real estate business and investments online.